38 lines
1.1 KiB
Plaintext
38 lines
1.1 KiB
Plaintext
#include <TimerOne.h>
|
|
|
|
// This example creates a PWM signal with 25 kHz carrier.
|
|
//
|
|
// Arduino's analogWrite() gives you PWM output, but no control over the
|
|
// carrier frequency. The default frequency is low, typically 490 or
|
|
// 3920 Hz. Sometimes you may need a faster carrier frequency.
|
|
//
|
|
// The specification for 4-wire PWM fans recommends a 25 kHz frequency
|
|
// and allows 21 to 28 kHz. The default from analogWrite() might work
|
|
// with some fans, but to follow the specification we need 25 kHz.
|
|
//
|
|
// http://www.formfactors.org/developer/specs/REV1_2_Public.pdf
|
|
//
|
|
// Connect the PWM pin to the fan's control wire (usually blue). The
|
|
// board's ground must be connected to the fan's ground, and the fan
|
|
// needs +12 volt power from the computer or a separate power supply.
|
|
|
|
const int fanPin = 4;
|
|
|
|
void setup(void)
|
|
{
|
|
Timer1.initialize(40); // 40 us = 25 kHz
|
|
Serial.begin(9600);
|
|
}
|
|
|
|
void loop(void)
|
|
{
|
|
// slowly increase the PWM fan speed
|
|
//
|
|
for (float dutyCycle = 30.0; dutyCycle < 100.0; dutyCycle++) {
|
|
Serial.print("PWM Fan, Duty Cycle = ");
|
|
Serial.println(dutyCycle);
|
|
Timer1.pwm(fanPin, (dutyCycle / 100) * 1023);
|
|
delay(500);
|
|
}
|
|
}
|